09 1000rr exhaust removal - Australian Bike

All

My fireblade exhaust has a second cable attached to it (first being the servo cable), it is electrical and seems to be a sensor of some sort. From reading other forums it is an o2 sensor I think and does not feature on USA spec blades. I have disconnected it from the stock pipe and followed the cable to as far as the engine cover near the gear lever. I can't figure out where it goes next or how to remove it.

My question for anyone re this cable:

1. what is it?
2. with an aftermarket can, is it safe to remove it? How do I remove it?
3. do I need an oxygen sensor eliminator plug - if so where do I plug it in.

My problem is that courtesy of 1000rr.net I have the usa tech manual which doesn't cover any of this.

Cheers
Mark

_________________
Mmamster
GSXR600 K7

1. what is it? o2 sensor
2. with an aftermarket can, is it safe to remove it? How do I remove it? yes. unplug it.
3. do I need an oxygen sensor eliminator plug - if so where do I plug it in. yes. in the exhaust.

you'll need an o2 sensor eliminator..... rrp $35 & a probe bung $15

$20,000 motorcycle
$2 mechanical

Laughing

PRICELESS

_________________
www.dynoverks.com.au
www.motospares.com.au

	Deano wrote:
	1. what is it? o2 sensor 2. with an aftermarket can, is it safe to remove it? How do I remove it? yes. unplug it. 3. do I need an oxygen sensor eliminator plug - if so where do I plug it in. yes. in the exhaust. you'll need an o2 sensor eliminator..... rrp $35 & a probe bung $15 $20,000 motorcycle $2 mechanical PRICELESS

Thanks Deano. I don't get what you mean by plugging the sensor eliminator into the exhaust, or what is the probe bung. I asume the O2 sensor cable runs into a plug, into which the 02 sensor eliminator goes? If so what is the probe bung for?

_________________
Mmamster
GSXR600 K7

If so what is the probe bung for?

to fill the hole where the sensor has been removed.... Very Happy

_________________
www.dynoverks.com.au
www.motospares.com.au